EGLO connect sensor

1. How to connect the sensor with the app?



Open the menu item "My sensors".

Go to top right on "+".

Press and hold the action button of the sensor for approx. 5 seconds.

When the button is released, the LED on the sensor starts flashing rapidly.

The sensor is detected.

Please follow the steps of the installation wizard.

Now you can make various settings:

  • Brightness threshold
  • Motion Sensor
  • Night Mode

Note that the modes can be activated individually or together!

Please click on the diskette at the top right before finishing each setting to save any changes you have made!

Brightness threshold:

Here you can set the brightness threshold, which determines at which brightness the sensor should switch.

As soon as the set threshold value is reached, the controller displays green.

(Attention: the transfer of the value from the sensor to the app can take a short moment)

Please set up the sensor at the location where it will be mounted so that the brightness threshold is set correctly.

If the brightness threshold is set incorrectly, the sensor may not react!

Motion Sensor:

Operate the motion detection according to your wishes!

You can select the duration, sensitivity, brightness and light colour as desired.

Night Mode:

In night mode, you can select your preferred light color and brightness.

As soon as the sensor detects that it is night, it switches on the set lighting!

Combination Motion & Night:

It is also possible to implement a combination of motion detection and night mode.

To do this, simply activate both modes in the settings. When night falls, the sensor detects this and switches to night mode. The luminaire shines with an intensity of approx. 20%.

If a movement is detected, the sensor switches the luminaire to 100% intensity for the set time.


2. How to adjust the sensor?



Open the menu item "My sensors".

To be able to make adjustments, you must always activate the sensor.

Press and hold the action button of the sensor for 5 seconds.

The sensor changes from a grey symbol to a bright symbol.

Press and hold the sensor icon in the app until the settings open.


3. How can I reset the sensor? (RESET)

To reset the motion sensor to factory settings, press and hold the button on the sensor for about 10 seconds.

After that, it starts flashing continuously if the RESET was successful.


4. How can I assign luminaires to the sensor?


Once the configuration is complete, you must assign the luminaires to be controlled to the sensor.

This works as follows:

Go to the menu item "My groups".

There you will find the sensor as an image.

Press and hold the sensor icon until the settings open.

Now you can assign the desired luminaires to the sensor, which it should control.

A check mark on the right edge of the screen selects the luminaires.

When you are finished, please save the settings by clicking on the diskette (upper right corner of the screen).


5. How do I delete the sensor from the app?

Open the menu item "My Controllers".

Press and hold the action button of the sensor for 5 seconds.

The sensor changes from a grey symbol to a bright symbol.

Press and hold the sensor icon in the app until the settings open.

To delete, click on the"trash can" icon in the upper right corner of the screen.

Confirm the deletion process.


6. Why does my luminaire not respond to the sensor?

Have you assigned the (correct) luminaires to the sensor?

If not, please go to "How can I assign luminaires to the sensor?"

If the assignment is correct, please check whether the brightness threshold is set correctly in the settings!

This is correct if the slider is green.

(Attention: the transfer of the value from the sensor to the app can take a short moment)

For further information, please see "Brightness threshold"under "How do I connect the sensor to the APP?